03-21-2007 01:43 AM - edited 03-05-2019 03:01 PM
Hi
For me to be able to configure QoS, VoIP, telephony, do I need the ipbase or enterprise version of the images?
This is a Cat4510?
Thanks
03-21-2007 02:06 AM
Hi
You should have IP Services feature set in your switch to have support for QOS..
do refer the below link which explains the same ..
http://www.cisco.com/en/US/products/sw/iosswrel/ps5460/prod_bulletin0900aecd80281b17.html
regds
03-21-2007 04:07 AM
Thanks
So from the document and below, where there is only ip base and ebterprise and what I am looking for, from the document, is in ip services, does that mean I will have to use the enterprise version?
Also what about the Basic L3? This is not explained. Thanks for your help.
Thanks
BASIC L3
BASIC L3 (RIP,ST.ROUTERS, IPX,AT)
BASIC L3 3DES
BASIC L3 3DES (RIP,ST.ROUTERS,IPX,AT)
ENHANCED L3
ENHANCED L3 (OSPF,EIGRP,IS-IS)
ENHANCED L3 3DES
ENHANCED L3 3DES (OSPF,EIGRP,IS-IS)
ENTERPRISE SERVICES SSH
ENTERPRISE SERVICES W/O CRYPTO
IP BASE SSH
IP BASE W/O CRYPTO
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: