ATA186 euro config help advice

Unanswered Question
Mar 21st, 2007
User Badges:

Hello all

i have configured an ATA186 to work with a H323 gateway, this will be used for fax. I think i have the config right but am a little concerned since last time i tried to get a fax to work with this device it failed. Can someone take a look at my config and tell me if it looks ok i am particularly interested in the settings i have on the ATA for audio and connection mode.


ata has latest h323 firmware


so settings on ATA are:

--are these ok for g711alaw?


Audio Mode 0x00150015

Connect Mode 0x90000400

my dial peer is the following


dial-peer voice 2684 voip

description fax to ata 2684

destination-pattern 2684

modem passthrough nse codec g711alaw

session target ipv4:10.230.62.220

incoming called-number 684

fax rate disable

no vad


Last time i tried this 2 years ago the fax kept missing lines of test, so i used a fxs port instead. Any help greatly appreciated.


Colin

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ReadersUK Thu, 03/22/2007 - 03:17
User Badges:

I thought i would answer my own question just incase someone is reading this.


the setting on ATA for europe should be

Audio Mode 0x00150015

Connect Mode 0x90002400 (the 2 sets codec to g711alaw


The cisco documentation only show examples for USA.Connect Mode 0x90000400 g711ulaw


hope this helps someone


colin








Actions

This Discussion