3750 disaster recovery

Answered Question
Mar 21st, 2007

My 3750 switch is not booting and is stuck at the prompt switch:

i tried to initialize the flash and load the IOS via the boot command but it gives an error.

Is there any xmodem procedure which i can do to load another software

I have this problem too.
0 votes
Correct Answer by Amit Singh about 9 years 6 months ago

Yes, you can use Xmodem to recover the switch. Please use the link below for recovering 3750 from softwaqre failures:


HTH,Please rate if it does.

-amit singh

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
mtechnology Wed, 03/21/2007 - 23:11

thanks for the link..

Is there anyway to increase the baud rate cos it is taking a long time to load the file with the normal rate

podhillo Mon, 06/07/2010 - 08:01

Please try the following steps to disaster recovery.

Do check the connections before proceeding:

dir flash:
set baud 115200 ---> for faster trasfer of image, do open a new hyper terminal with baud rate set to 115200.
copy xmodem:flash:

More details provided in the following link:

Hope it helps!




This Discussion