4500

Answered Question
Mar 22nd, 2007

Dear All,


I am having 4507R chassis in whcih two SUPs are installed .


in case of failure of Redundant SUP,I want to copy the image which is running on Active SUP to my redundant SUP ( at time when new Redundant SUP is installed )


can i get document on same ?


regds,

aman

Correct Answer by Jon Marshall about 9 years 11 months ago

Hi


From the 4500 configuration guide


"Copying Files to the Standby Supervisor Engine

If you want to manually copy a file from the active supervisor engine to the slot0: device on the standby supervisor engine, use this command:


Switch# copy source_device:source_filename slaveslot0:target_filename

To copy a file to the bootflash: device on a standby supervisor engine, use this command:


Switch# copy source_device:source_filename slavebootflash:target_filename"


Attached is the full link to the 4500 redundancy documentation



http://www.cisco.com/en/US/products/hw/switches/ps4324/products_configuration_guide_chapter09186a0080233f9e.html


HTH


Jon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (2 ratings)
Loading.
Correct Answer
Jon Marshall Thu, 03/22/2007 - 02:13

Hi


From the 4500 configuration guide


"Copying Files to the Standby Supervisor Engine

If you want to manually copy a file from the active supervisor engine to the slot0: device on the standby supervisor engine, use this command:


Switch# copy source_device:source_filename slaveslot0:target_filename

To copy a file to the bootflash: device on a standby supervisor engine, use this command:


Switch# copy source_device:source_filename slavebootflash:target_filename"


Attached is the full link to the 4500 redundancy documentation



http://www.cisco.com/en/US/products/hw/switches/ps4324/products_configuration_guide_chapter09186a0080233f9e.html


HTH


Jon

Actions

This Discussion