config management using telnet

Unanswered Question
Mar 22nd, 2007
User Badges:

Since I reinstalled CW, telnet doesn't seem to work anymore. CW always uses tftp or another procotol. telnet is always first choice in the admin section. When I do a telnet from another app it works. What could be wrong in CW ?

My system runs on Sun Solaris 8


Many thanks,

Lieven Stubbe

Belgian Railways

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
David Stanford Thu, 03/22/2007 - 06:50
User Badges:
  • Cisco Employee,

Try removing everything except telnet from your transport protocols. Then enable a packet capture to determine what is happening when RME is telnetting to the device. Use Follow TCP Stream in Ethereal/Wireshark to read the TCP output in the packet capture.


you could also turn on debugs for archive management and look at the dcma logs

Actions

This Discussion