IP Phone Services for Developers: Headset Button State

Unanswered Question
Mar 22nd, 2007

I'm trying to determine the state of the Headset Button on 794X 796X but can't seem to find the right call. Of course I am able to progamatically set the state but I need to check the state beforehand...preferably without having to resort to (J)Tapi.

Any guidance would be most appreciated.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
stephan.steiner Thu, 03/22/2007 - 22:05

Have you checked if there's a difference in the phone status page (the one you can get by accessing the phone's IP in a web browser) when that button is pressed (versus when it isn't)? But I suppose there'd be no difference between the headset and the speaker button being pressed.

I'm not even sure JTAPI can do it.. I know the entire number block is supported but I don't recall if any other buttons (and which) are supported.. all I can tell you without looking at the documentation is that not all of the buttons can be monitored (plus you only get state changes).

ltleary2000 Fri, 03/23/2007 - 05:42

Thanks for the reply Stephan, and yes I did check the status page (to no avail.)

I'll keep looking!



This Discussion