03-22-2007 07:00 AM - edited 03-03-2019 04:15 PM
Hi I have a quick question I have a point to point frame relay circuit and at night an FTP run that floods this circuit causing it to be unusable till the FTP is finished. Question is how do I configure QoS on it so I can make the FTP a low priority. I have a 2811 running c2800nm-adventerprisek9-mz.123-14.T7.bin software on it.
03-22-2007 07:24 AM
Hi,
This document might help you:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a0080080122.html
Regards,
Juan
03-27-2007 06:26 AM
please find sample configs below;
#
class-map match-all FTP
match protocol ftp
!
policy-map POLICE_FTP
class FTP
set ip precedence 0
!
int XX
service-policy output POLICE_FTP
OR
#
map-class frame-relay FRTS
service-policy output POLICE_FTP
!
class-map match-all FTP
match protocol ftp
!
policy-map POLICE_FTP
class FTP
set ip precedence 0
!
int XX
frame-relay class FRTS
Please rate if this helps.
03-27-2007 07:46 AM
Warren,
If you don't have any voice traffic, you can try Weighted Fair Queuing (WFQ), which is very easy to configure (fair-queue), and works well for protecting interactive traffic from FTPs.
Please rate helpful posts.
Dave
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: