03-22-2007 07:16 AM
hi,
I know i can split a PRI in a various ways, what i would like to know is how can i split the PRI and then push the groups to specific BRI ports.
e.g. i have a PRI with 20 lines, i would like to separate it into 4 BRIs and the rest, could i add two vic-bri cards and send those PRI groups/channels to the physical BRI ports so that a customer could plug their stuff in to the ports and then use the rest as normal
I imagine it is something like ds0-groups or trunk-groups but then how can i assign it to a bri, would i use something like a voice-port command etc.?
cheers
paul
03-22-2007 09:56 AM
Absolutely, the following good doc has all the info you need:
http://cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00804794c6.shtml
pri and bri are voice port and you have an all "dial-peer pots" config.
Hope this helps, please rate any useful posts!
03-22-2007 10:25 PM
I believe the following application note on Cisco.com will be of interest to you -
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00804794c6.shtml
The technique is called TDM backplane switching.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide