Maximum no. of calls for VGC

Unanswered Question
Mar 22nd, 2007
User Badges:

Hi All,

is there possible way to increase the Maximum number of call from 2 to more?


i tried to increase the maximum number but its getting me error, and the message says the maximum no. is just only 2..


can anybody help me?..

Thank you very much in advance..


Best Regards,

Lester

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Fri, 03/23/2007 - 05:43
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Lester,


Unfortunately there is no way around this parameter :( You can configure up to 200 calls for a line on a device in a cluster, with the limiting factor being the device. As you configure the number of calls for one line, the calls available for another line decrease. Cisco IP Phones that support the multicall display (such as a Cisco IP Phone 7960) support up to 200 calls per DN and 2 calls per DN for non-multicall display devices (such as VGC Analog phone or Cisco IP Phone 7905). This is really due to the fact that there is no way to properly handle more than 2 calls at a time on these type of phones.


From this good doc;


http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00801ec5a6.html#1062557


Hope this helps!

Rob



Actions

This Discussion