Unity not disconnecting

Unanswered Question
Mar 23rd, 2007
User Badges:


I have a problem when we call and unity answers; if we hang off the phone during the operator speech (during "welcome to the automated attendant, if you ..."), the FXO port of the CALL manager express bundle remains on instead of going off, so if we re-call the same number, it gives busy. The number stop being busy when the FXO port goes off (=when the time of the speech of the operator ends).

Please advice

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Rob Huffman Fri, 03/23/2007 - 13:22
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Tarek,

My guess here is that you are running into a "Disconnect Supervision" issue on the FXO. Once the method of disconnect the circuit uses has been determined, you can configure the FXO appropriately. Have a look;

FXO Disconnect Supervision


Hope this helps! I know it doesn't answer your question completely but maybe it will head you in the right direction.



This Discussion