cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
251
Views
0
Helpful
1
Replies

lost of the IOS Ap series 1100

soporte.cisco
Level 1
Level 1

How can i recover the funcionality of the AP? the AP1120B lost the IOS (autonomous) that it had and now dont work.

This only

1 Reply 1

csannedhi
Level 1
Level 1

You need to run a TFTP server (download a TFTP server from http://tftpd32.jounin.net/)on the local machine and set the local machine's IP address between 10.0.0.2-10.0.0.30. Here is the entire procedure:

Step 1 The static IP address of the PC on which your TFTP server software runs should be between 10.0.0.2 and 10.0.0.30.

Step 2 Make sure that the PC contains the access point image file (such as c1200-k9w7-tar.122-15.JA.tar for a 1200 series access point) in the TFTP server folder and that the TFTP server is activated.

Step 3 Rename the access point image file in the TFTP server folder to c1200-k9w7-tar.default for a 1200 series access point, c1130-k9w7-tar.default for an 1130 series access point, and c1240-k9w7-tar.default for a 1240 series access point.

Step 4 Connect the PC to the access point using a Category 5 (CAT5) Ethernet cable.

Step 5 Disconnect power from the access point.

Step 6 Press and hold MODE while you reconnect power to the access point.

Step 7 Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds) and then release.

Step 8 Wait until the access point reboots, as indicated by all LEDs turning green followed by the Status LED blinking green.

Step 9 After the access point reboots, reconfigure it using the GUI or the CLI.

HTH

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: