cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
276
Views
4
Helpful
1
Replies

Configration in 4500 catalyst switch

manojkumarnb
Level 1
Level 1

I have a catalyst 4507R switch. I would like to add two modules (24 port WS-X4424-GB-RJ45 and WS-X4418) in the existing 4507R switch. Do these modules are plug and play or I have to do some configurations in the supervisor? If any configuration needed then what is that?

1 Reply 1

ankbhasi
Cisco Employee
Cisco Employee

Hi Manoj,

Yes all line cards are plug and play and if your IOS release running on your supervisor supports these cards, they will automatically get detected and will move to OK state.

After that it is only the port configuration which you have to do on the line cards interfaces.

HTH

Ankur

*Pls rate all helpfull post

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco