Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
255
Views
0
Helpful
2
Replies

Switches configuration in VMWARE environnement

rdubo
Level 1
Level 1

‎03-26-2007 07:33 AM - edited ‎03-05-2019 03:05 PM

Hi,

Is it possible to add some commands to improve VMWARE server connected to Cisco Switches.

The VMWARE Servers use the same card for whole servers on them.

regards,

Labels:
0 Helpful
2 Replies 2

Amit Singh
Cisco Employee
Cisco Employee

‎03-26-2007 07:47 AM

Hello,

Which switch is this ?

You can enable spanning-tree portfast on the the switchports connected to the server. Disable DTP/PAGP negotiations on the ports connected to the server.You can haddcode the speed/duplex on the ports and the serverside if you have any speed/duplex issues.

HTH,

-amit singh

0 Helpful

rdubo
Level 1
Level 1
In response to Amit Singh

‎03-27-2007 12:12 AM

Switches are 2960. The configuration seems to be like you specified. I would like to know if there were specific command thant can be added for VMWARE.

Thanks

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card