ospf load balancing

Answered Question
Mar 26th, 2007
User Badges:

hi

we are facing load balancing problem.

Details of network set up is given in attached msword document.

Any suggestions..

Thanks in advance

Subodh



Correct Answer by parthibanp about 10 years 2 months ago

Hi


Try enabling per packet load balancing on the involved interfaces (seria&ethernet) on all the rotuers involved.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Amit Singh Mon, 03/26/2007 - 10:20
User Badges:
  • Cisco Employee,

Subodh,


Can you please post the config from both R1 and R3 and also "show ip route "


-amit singh

bapatsubodh Tue, 03/27/2007 - 11:19
User Badges:

Dear Mr. Singh,

all routers R1, R2, R3, and R 4 are all 7507 series routers having more that 800 rouets. SO i think it's practically difficult to caputre o/p or sh ip route. Can i post any particular routes , wherein router shows two paths of equal cost to destinations.

Pls. ack back.

( Also I will try per packet switching if possible as mentioned in second reply )

Thanks and Regards.

Subodh

Correct Answer
parthibanp Mon, 03/26/2007 - 11:11
User Badges:

Hi


Try enabling per packet load balancing on the involved interfaces (seria&ethernet) on all the rotuers involved.

Actions

This Discussion