CatOS to IOS Conversion

Unanswered Question
Mar 26th, 2007

In preparation of my 6500 CatOS to Native IOS conversion, I ran my configuration through the online configuration tool. While it did a good job, there was a few lines that didn't convert which require manual editing.

My question is that I can't find equivalent commands to convert the following statements:

set qos wrr 2q2t 5 255

set qos wrr 1p2q2t 5 255

set qos wrr 1p2q1t 5 255

Anyone know equivalent commands to these?

Thanks,

Joe

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sundar.palaniappan Mon, 03/26/2007 - 12:45

Joe,

The following link has the info you need. Use this document to calculate the corresponding values in your case.

http://www.cisco.com/warp/public/473/152.html

For eg, the 1st statement in your config should transalate to as follows in the IOS mode.

CatOS:

set qos wrr 2q2t 5 255

Native IOS:

int

wrr-queue bandwidth 1 51

HTH

Sundar

Actions

This Discussion