Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
318
Views
0
Helpful
1
Replies

VPN on PIX to client

jkoven
Level 4
Level 4

‎03-26-2007 01:35 PM - edited ‎02-21-2020 02:56 PM

I am trying to build remote client VPN's on a PIX running 6.3.3 code. The client get's an address, but no gateway, and is not able to get around the inside interface network on the PIX. Is this a NAT issue, a gateway issue, or a routing issue?

Labels:
0 Helpful
1 Reply 1

Kamal Malhotra
Cisco Employee
Cisco Employee

‎03-26-2007 02:02 PM

Hi,

Are you able to ping the inside interface of the PIX? For confirmation, please enter the command 'man i' in the config mode on the PIX and then ping the inside interface of the PIX from the client. If this works, then please check the following :

1. nat (inside) 0 configuration.

2. Access-list on the inside interface.

3. Default gateway in the inside hosts.

If you are not able to ping the inside interface then you might need 'isakmp nat-t' command on the PIX.

HTH,

Please rate if it helps.

Regards,

Kamal

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents