Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
346
Views
0
Helpful
3
Replies

AutoLearn and Annex-D

corey.mckinney
Level 1
Level 1

‎03-27-2007 10:40 AM - edited ‎03-03-2019 04:19 PM

I was told by AT&T that I needed to make sure my router was set to AutoLearn and Annex-D. What exactly is this and how do I configure it? I'm using a 2811 with a T1 CSU/DSU WIC.

Thanks.

Labels:
0 Helpful
3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

‎03-27-2007 02:26 PM

Hi, these are the LMI standards for your Frame Relay T1. Just configure lmi-type ansi and the pvc (dlci) number given by the SP.

Hope this helps, please rate all useful posts!

0 Helpful

corey.mckinney
Level 1
Level 1
In response to paolo bevilacqua

‎03-27-2007 02:57 PM

That's fine, however, I've been running lmi-type cisco for 3 years since this circuit was installed. Why would I have to change it now? Thanks.

0 Helpful

paolo bevilacqua
Hall of Fame
Hall of Fame
In response to corey.mckinney

‎03-27-2007 04:05 PM

Not necessarily, in fact the switch may even be auto-sensing LMI. You may ask telco why they are telling you that and if it means they are changing something.

Hope this helps, if so please rate post

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card