03-27-2007 03:25 PM - edited 03-05-2019 03:08 PM
I just purchased the Cisco 1841 Security bundle w/ a T1 WIC and also purchased the WIC-4ESW card, but the ports are not recognized. According to the WIC-4ESW says minimum is 12.3(8)T (fourth release of Cisco IOS Software Release 12.3T). My router's current version is - System image file is "flash:c1841-advsecurityk9-mz.124-3g.bin"
Any idea why?
03-28-2007 01:37 AM
Hi
Pls find the IOS code/DRAM/FLASH required in your router to have both security bundle as well as to support the desired hardware..
192 64 12.4(11)T1 c1841-advsecurityk9-mz.124-11.T1
128 32 12.4(10a) c1841-advsecurityk9-mz.124-10a
128 32 12.3(8)YG4 c1841-advsecurityk9-mz.123-8.YG4
128 32 12.3(14)T7 c1841-advsecurityk9-mz.123-14.T7
regds
03-28-2007 08:12 AM
Well, I loaded BOTH
c1841-advsecurityk9-mz.124-11.T1.bin
c1841-advsecurityk9-mz.124-10b.bin
and still does not work.
#show diag
WIC/HWIC Slot 1:
Unknown WAN daughter card
WIC module not supported/disabled in this slot
03-28-2007 08:38 AM
WIC-4ESW is not supported on 1841 router.
the replacement is HWIC-4ESW.
for details please review:
http://www.cisco.com/en/US/products/ps5853/products_qanda_item0900aecd80181208.shtml
at the Question "Q. Are any WICs not supported on the Cisco 1841 router?"
03-28-2007 12:13 PM
That would make sense, I do in fact have the WIC-4ESW. I RMA'd the one I have for the HWIC. As always, this is for a project that was due "yesterday".
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: