converged data and voice network

Unanswered Question
Mar 28th, 2007
User Badges:

hi

i need advice on setting up a converged data and voice network.The wan uses 2M Leased lines.The leased lines were originally used for voice only while data was running on a Frame-relay circuit of 128k.Since the voice network seemed to be underutilised the customer wants to move the data network to the exiting voice leased lines.


My question is what interfaces should i use on my routers as shown in the Diagram.where can i get an example config of a point to point E1 leased line on a cisco router especilaly 3825 and 2821.

the customer is using a mite solution for voice and does not want to migrate to cisco Voip due to a contract signed with mitel.




Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
hoogen_82 Wed, 03/28/2007 - 03:56
User Badges:
  • Silver, 250 points or more

Well getting specificall to your question about how to configure point to point E1 leased line


For Unframed configuration


!

controller E1 3/0

channel-group 0 unframed

!

interface Serial3/0:0

ip address 40.0.0.1 255.255.255.0

ip mroute-cache

!


For other configurations this would be useful

Here we are binding 16 timeslots.

!

controller E1 4/0

channel-group 1 timeslots 1-16

!

interface Serial4/0:0

ip address 30.0.0.1 255.255.255.0

encapsulation ppp

!


Links that could be useful


http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a00800e976b.html


More specific

http://www.cisco.com/en/US/products/sw/iosswrel/ps1826/products_configuration_guide_chapter09186a00800d9bc0.html#xtocid2513227


http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a00800e9762.html#1019916


http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a00800e9762.html#1019869


HTH

Hoogen


Do rate if this helps :)

Actions

This Discussion