Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
326
Views
0
Helpful
1
Replies

IPSEC problem between Cisco Router and Netscreen 5GT

D
Level 1
Level 1

‎03-28-2007 06:24 AM - edited ‎03-11-2019 02:52 AM

isakmp is working.

fase 2,Ipsec does not work:

IPSEC(validate_proposal): transform proposal (prot 3, trans 3, hmac_alg 1) not supported

Labels:
0 Helpful
1 Reply 1

carenas123
Level 5
Level 5

‎04-03-2007 05:51 AM

To my knowledge, the problem might be the transform set mismatch or the tunnel group mis match name.

This document provides an explanation of common debug commands that are used to troubleshoot IPsec issues on both the Cisco IOS? Software and PIX. It is assumed that an attempt to configure IPsec is completed. Refer to Common IPsec Error Messages and Common IPsec Issues for more details.

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_tech_note09186a008009448c.shtml

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card