BGP aggregate-address

Unanswered Question
Mar 28th, 2007

What is the difference in using an attribute-map instead of a route-map as paramenter of the

bgp aggregate-address command?


From the "?"

attribute-map Set attributes of aggregate

route-map Set parameters of aggregate


Thanks to read.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (2 ratings)
Loading.
owaisberg Wed, 03/28/2007 - 07:12

Hello,


attribute-map and route-map are equivalent

and do the same job, so no difference whatsoever beside the name.


HTH,

OW


* Please rate all useful posts

royalblues Wed, 03/28/2007 - 09:26

Friend,


Though they perform the same thing, it should be noted that the attribute-map command can only be used along with the aggregate command and it references a route-map


Whereas the route-map can be used with almost anything for implementing the routing policy.


HTH, rate if it does

Narayan

owaisberg Wed, 03/28/2007 - 09:42

Narayan,


You are correct, however original question

was about the difference between these two

commands when both used with aggregate.

And as per aggregate usage, these two are

identical.


HTH,

OW

Actions

This Discussion