03-29-2007 01:56 AM - edited 03-14-2019 08:45 PM
When running phones in SRST (7912/7940/ATA) I am finding that the second call to an extension does not get engaged, only the 3rd. Much the same as if you had the "BUSY TRIGGER" set to 2 rather than 1 in normal CM operation. Is there a way to prevent this so that all calls are given engaged tone, if the extension is already on a call, rather than allowing 1 caller to wait ?
Solved! Go to Solution.
03-29-2007 02:40 AM
If you have a dual-line phone configuration, use "huntstop channel" command to avoid hunting of call to the second line.
hth
mehmet
03-29-2007 02:40 AM
If you have a dual-line phone configuration, use "huntstop channel" command to avoid hunting of call to the second line.
hth
mehmet
03-29-2007 03:34 AM
Thats seems to have worked. Thanks very much. I did also have to add "huntstop" to the "call-manager-fallback" config as the call was then matching an additional unwanted dialpeer rather than stopping on engaged.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: