Err-disable port on switches

Answered Question

Hi,

I run LMS 2.6 and I wonder to know how to monitor err-disabled ports. I want to configure an alert and afterward get this alert on e-mail. I already configured event sets. Is the err-disabled state a trap or syslog event??

I am a newbie on ciscoworks.

Thanks

I have this problem too.
0 votes
Correct Answer by david.fernandes... about 9 years 10 months ago

Here are the ones I use for Automated Actions:

SYS-*-3-PORT_COLLDIS:*

PM-*-4-ERR_DISABLE:*

Correct Answer by superiortribunal about 9 years 10 months ago

The syslog is like this:

%PM-4-ERR_DISABLE: link-flap error detected on Fa0/3, putting Fa0/3 in err-disable state

Create an automated action on RME->Tools->Syslog

You can send e-mail.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
superiortribunal Thu, 03/29/2007 - 15:10

The syslog is like this:

%PM-4-ERR_DISABLE: link-flap error detected on Fa0/3, putting Fa0/3 in err-disable state

Create an automated action on RME->Tools->Syslog

You can send e-mail.

Correct Answer
david.fernandes... Thu, 03/29/2007 - 18:45

Here are the ones I use for Automated Actions:

SYS-*-3-PORT_COLLDIS:*

PM-*-4-ERR_DISABLE:*

I followed the RME guide to set the syslog automation action. The ERR disable appears in syslog.

My smtp server is configured in CS/server/admin/system preference. I ping the smtp, I use telnet ip 25 to test the smtp and it's ok. The smtp that I use is microsoft esmtp mail service.

How can i debug that, the ciscoworks don't send any e-mail.

Thanks

Actions

This Discussion