Solved: Firewall with only internal interfaces - no NAT/PAT

jilahbg · ‎03-29-2007

Hello

I have a firewall (in this case a context within a FWSM, but I guess this applies also to any ASA) with only internal interfaces. That is, no interface is connected to internet, and there is no need for any address translation thru the fw.

What do I need to do to configure the firewall to not bother about NAT/PAT at all, and forward traffic only based on ACL:s?

The command "no nat-control" is a good start. But is there more that needs to be done?

Best regards

Jimmy

Jon Marshall · ‎03-30-2007

Hi Jimmy

That command will pretty much do it. Make sure once you have entered this command that you then don't have any nat/global statements as these would still be executed.

HTH

Jon

View solution in original post

Jon Marshall · ‎03-30-2007

Hi Jimmy

That command will pretty much do it. Make sure once you have entered this command that you then don't have any nat/global statements as these would still be executed.

HTH

Jon