WEP encryption after AP reload and no show run output

Unanswered Question
Mar 29th, 2007

Hello,we have an interesting incident.

We have added a second VLAN and SSID into the AP configuration. The first SSID is configured by WEP. After the configuration was finished there are any clients associated to the access point but not all clients are able to transfer packets to the wired network.Some clients are able to work and some clients are not able to work.When we perform a reload of the access point all clients are able to send and receive data packets again.

Another issue is when we do a "show run" there is no output in CLI. We had access to the AP via telnet. After the reboot this issue is solved,too.

I think it looks like a memory problem.

Is there anybody who had the same problem?



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode