03-30-2007 06:46 AM - edited 03-05-2019 03:12 PM
Hello All,
I hav Cisco 2621 Router, i just ordered flash memory(32MB FS).
I have installed the flash memory in to the router by removing older one, but as i boot the router router goes in to ROMMON as it dosent has any IOS, now i am trying to download the IOS from ROMMON using "tftpdnld" switch but it says the Flash is not formated.
so How can i format the new FLASH to load any IOS in to that.
Thanks,
Dhaval Tandel
03-30-2007 06:53 AM
Dhaval,
you can use the format flash: command in the Rommon mode to foramt the flash.
check out the following links
http://www.cisco.com/en/US/products/hw/routers/ps341/prod_installation_guide09186a00802a6394.html
HTH, rate if it does
Narayan
03-30-2007 07:10 AM
Thanks for takin interest,
I dont have format command supported on present ROMMON.
rommon 15 > ?
alias set and display aliases command
boot boot up an external process
break set/show/clear the breakpoint
confreg configuration register utility
cont continue executing a downloaded image
context display the context of a loaded image
cookie display contents of cookie PROM in hex
dev list the device table
dir list files in file system
dis display instruction stream
dnld serial download a program module
frame print out a selected stack frame
help monitor builtin command help
history monitor command history
meminfo main memory information
repeat repeat a monitor command
reset system reset
set display the monitor variables
stack produce a stack trace
sync write monitor environment to NVRAM
sysret print out info from last system return
tftpdnld tftp image download
unalias unset an alias
unset unset a monitor variable
xmodem x/ymodem image download
Thanks
Dhaval Tandel
03-30-2007 07:27 AM
Dhaval,
Can you just try executing the command ?
Narayan
03-30-2007 07:30 AM
It says command not found
thanks
dhavl
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: