what situations can casue fabric lock

Unanswered Question
colin.mcnamara Sat, 03/31/2007 - 15:38
User Badges:
  • Bronze, 100 points or more

Fabric lock is a function of CFS.

A fabric lock is issued when when one switch in the fabric attempts to configure a CFS enabled application.


The fabric lock is released when the change is committed to the fabric.


You can learn more about it by reading this link -

http://www.cisco.com/en/US/products/ps5989/products_configuration_guide_chapter09186a008040f9f2.html


If you find this useful, please rate this.

Thanks for your infomation.


In my configrations, I can not active IVR zoneset due to existing Qlogic SANBox switch.

And I found some information as following:


Be sure to add IVR virtual domains if the following conditions apply:

?When an IVR zone set is not active.

?If Cisco SN5428 or Qlogic SANBox switches exist in the VSAN.


So, I need to add some domains (domain id?) to IVR configurations, right?



colin.mcnamara Sun, 04/01/2007 - 19:59
User Badges:
  • Bronze, 100 points or more

Yeah, that is a nice piece of the puzzle.

The issue is covered in this link -

http://www.cisco.com/en/US/products/ps5989/products_configuration_guide_chapter09186a008040fa3a.html

But in essence, there is a name resolution problem.


If you define a virtual domain in your ivr config (howto is in the link) it will allow the two fabrics to become fully aware of each other.


--Colin

Actions

This Discussion

 

 

Trending Topics: Storage Networking