Wireless Problem

Unanswered Question
Apr 1st, 2007
User Badges:

Hello,

I have just implemented my first 877w router.


I used the gui for the configurations (excluding the wireless part).


I then followed a cisco tutorial in setting up wireless (the one with the ssid and relating it to vpn1).

I did all the tutorial except for the bridging part which I assume I don't need.


However, when I do: #show .. associations


(where .. is the word that includes an 11 in it -can't remember it from the top of my head-)


I see my only SSID linked to VPN as 'DISABLED'. I tried lots of things including no shutdown in the ssid mode, shutdown vpn1 (thinking I can re enable it - but guess what I lost my telnet session, lol).


I googled for a bit, but I wasn't able to find a solution.


How can I fix this?

Thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
bporter78 Fri, 04/06/2007 - 09:24
User Badges:

what you need to do is bridge vlan1 and your wireless into bridge-group 1


Then you setup BVI1 (bridge-group 1) with the IP address, access-lists etc that you want


Then apply your vpn crypto map to your dialer0 interface and there you have it.


Traffic from both your wi-fi and wired devices will go across your VPN


If you email me your config I can have a look at it and make the changes that you need and send it back to you


[email protected]

Actions

This Discussion