Hello
I have a cisco 1811, and i want to configure the switch to use the ports in diferent VLAN's. lets say i have set the FE0 with the ip 20.20.20.254, this is were i get the information from.
the 8 ports that i have I want to divide in 3 VLAN's
port 2-3 10.10.10.0-10.10.10.63
port 4-5 10.10.10.64 - 10.10.10.127
port 6-9 10.10.10.128 - 10.10.10.255.
is this possible?
How do i separate in VLAN's?
do i have to configure the Vlans with the gateway address that each subnet will use and than route each gateway through the FE0 interface?
Please help me
regards