1242AG Signal Strength

Unanswered Question
Apr 2nd, 2007

First time using Cisco was a Motorola user at my old company. I have is set up as a root bridge and have about 3 remote sites all about 2 miles away just using point to point. I have the root set tp max power. One remote keeps disconnecting a few times a day. How do I see the signal strength there I'm getting. I have two hard dishes so distant at 2 miles should not be a proble but I dont like it when I cant see a DB level in the gui interface as in Motorola's Canopy. What do I need to do.

Thanks

DK

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
brispin Fri, 04/06/2007 - 08:23

The frequent disconnections may be due to some kind of RF interference between the root and non root bridges. Did you try raising the height of the antenna? This might resolve the issue.

dkdaniels48 Fri, 04/06/2007 - 21:50

Well I have it on a 64 foot self supporting tower. Is there any way to see what the signal strength is.

Thanks

DK

Actions

This Discussion