cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1218
Views
0
Helpful
3
Replies

Throttling Switch Port Bandwidth

mruhenkamp
Level 1
Level 1

I have a gigabit switch port on a 3550 that I wish to limit the bandwidth down to 10 mb. Any recommendations on how to do this? I have tried the config below:

class-map match-any Internet

match access-group 100

!

access-list 100 permit ip any any

!

policy-map PoliceInternet

class Internet

police 10000000 1250000 exceed-action drop

But when I try to apply it to the gig interface, I get the following in the log:

%QM-4-CLASS_NOT_SUPPORTED: Classification is not supported in classmap Internet

3 Replies 3

situwayne
Level 1
Level 1

how about this easy approach...hardcode the port speed to 10mb? but be sure that connected device is configured 10mb or auto-negotiate.

This is a switch and as far as I know, you can't simply hardcode the switchport speed or set a bandwidth statement limiting the bandwidth.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: