04-03-2007 03:05 AM - edited 03-03-2019 04:23 PM
I have a SOHO 97
Router and IOS Information
-------------------------------------
Router Model : SOHO97
IOS Image Name : soho97-k9oy1-mz.123-8.T5.bin
IOS Version : 12.3(8)T5
for some reason, whenever the power is reset or the unit rebooted, it looses the configuration and reloads the default one. I have to use the console port and copy the config over again. I have issued a WRITE MEMORY which is successful, but the system will not load on restart - what am i doing wrong?
Many thanks in advance
04-03-2007 03:35 AM
Can you post the "show version" output? I suspect the last line is something other than 0x2102.
If the router is new, after you configure it, you need to set the configuration register to 0x2102 which is shown in the last line of the "show version" output.
To set the configuration register to 0x2102;
Router# config t
Router(config)#config-register 0x2102
Save the config. The next time you reload or power cycle the router it will use configuration register 0x2102 and load the save config.
http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a65a5.shtml
04-03-2007 03:40 AM
Thanks Medan, will check that tonight and report back
Thanks again
04-04-2007 07:49 AM
it was set to 0x242 - have reset to 0x212 jusr need to test now - many thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide