Supervisor Module Upgrade Advice Please

Unanswered Question
Apr 3rd, 2007

Hi Folks,

I need to replace a dozen SUP1A's running CatOs with WS-X6K-S2-PFC2's and copy the configs over.

I don't think I can just put a Sup2 into slot 2 and have the configs sync with the active Sup 1A in slot 1 because the hardware is different, right ?

I have a spare 6509 chassis I can use to build the WS-X6K-S2-PFC2's one at a time, cut and paste in the configs, and then swap the 2's with the production 1A's, but is there a better way to accomplish what I'm trying to do ?

Any advice or experience you can share would be very greatly appreciated.

Thanks,

Rich

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
ankbhasi Wed, 04/04/2007 - 04:26

Hi Rich,

Yes you are right sup 1a and sup 2 are different hardware so both cannot reside at a same time in single chassis and will not synch the config.

The best way will be to use a seperate chassis as you mentioned and make one sup 2 ready and then replace sup 1a and insert sup 2. Once sup 2 is active then you can keep inserting other sup 2s in same chassis in standby slot and can get the config synched.

HTH

Ankur

Actions

This Discussion