04-03-2007 07:52 PM - edited 03-13-2019 04:02 PM
Hi all,
I've notice this issue happening when the VG router recovers from SRST thus downloading the configuration from the Cisco CallManager. I'm just wondering is the a way to set the Call Manager to have the settings below. Thank in advance.
---- Current / Initial config ----
controller E1 0/0/1
framing NO-CRC4
pri-group timeslots 1-16 service mgcp <<<<<<<<<< We had to split the timeslots as the router doesn't have enough DSP ports
!
!
controller E1 0/1/0
framing NO-CRC4
clock source internal
pri-group timeslots 16-31 service mgcp
!
!
interface Serial0/0/1:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn incoming-voice voice
isdn bind-l3 ccm-manager
no cdp enable
!
interface Serial0/1/0:15
no ip address
encapsulation hdlc
no logging event link-status
isdn switch-type primary-qsig
isdn protocol-emulate network
isdn incoming-voice voice
isdn bind-l3 ccm-manager
no cdp enable
-----------------------------------------
---- After recovering from SRST & configs downloaded from CCM ----
controller E1 0/0/1
framing NO-CRC4
!
controller E1 0/1/0
------------------------------------------------------------------
04-09-2007 11:14 AM
Appears that is a bug.
IOS used? can you upgrade and try again?
04-12-2007 10:16 PM
Currently running IOS 12.4(6)T6. I don't think it's a bug but more of the Call Manager settings as the router will download a config once it has established a ccm connection. Hope this helps
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide