04-03-2007 09:17 PM - edited 03-05-2019 03:17 PM
Can any one suggest me whether NM-1E = Description 1-port Ethernet Network Module) support in cisco 2600 router.
04-03-2007 09:46 PM
Hi
As per the supporting doc it supports..
http://www.cisco.com/en/US/products/hw/routers/ps259/products_relevant_interfaces_and_modules.html
regds
04-03-2007 10:05 PM
Thanks for your reply.
But there it mentioned cisco 3600 series not mentioned any where 2600.
Do 2600 support additional ethernet interface.
Regards
Anup
04-03-2007 10:48 PM
Hi Anup
you can make use of the below tool to find out whether your router model supports the required hardware and also the software required to have in the box..
http://tools.cisco.com/Support/Fusion/FusionHome.do
regds
04-03-2007 11:31 PM
Dear Prem
Is this link protected? i cannot access this tool.
Thanks
Anup
04-03-2007 11:43 PM
Hi
It should support NM-1E.
But wont support any Ethernet with WIC slots(NM-1E2W etc)
Regards
JD
04-12-2007 10:52 AM
Yes it does, for sure.
Klean
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: