Access denied

cisconoval · ‎04-04-2007

Hi there,

there is two servers one is on VLAN10 and another on VLAN20.

User needs the access between these server on port 80. I tried to telnet on port 80 from to these servers from its respective VLAN which was successfull. But from the server its blocking. I have checked the ACLs there is no such thing to block. the ACL is like this

permit tcp any any reflect tcptraffic.

Can some shen a light on this at the earliest

Thanks in Adv

cisconoval · ‎04-04-2007

can some one help me please...its very urgent..

If I have missed out any information please let me know

Thanks

royalblues · ‎04-04-2007

On which side of the switch is this access-list applied?

Narayan

cisconoval · ‎04-04-2007

placed on VLAN10(source) as out

royalblues · ‎04-04-2007

Can you try to add the access-list on the other vlan too and check

Narayan

cisconoval · ‎04-04-2007

I hope its not required because from Vlan10 to server I can telnet but from server on VLan10 only its not happening...!!!

Why it is happening like this what would be the root cause please...

cisconoval · ‎04-04-2007

Is any more suggesstion please.

Did ping and tracert from Server A(VLAN10) to Server B (VLAN20) which was successfull..

avmabe · ‎04-04-2007

Take out the ACL and what happens?

cisconoval · ‎04-04-2007

I hope the secinario is confused for you...

Just to recall..

I can telnet from switch (Vlan interface to server) but not from particular server..

more over the ACL is

permit tcp any any reflect tcptraffic

avmabe · ‎04-04-2007

Ok then... post switch config and servers ip configuration and mask/gateway information

cisconoval · ‎04-05-2007

Can you please guide me the troubleshooting steps..as its policy violation I cant post the config details more over its Distribution layer switch....so masking the sensitive info is bit tough...

please