3 FWSMs and CSM

Unanswered Question
Apr 6th, 2007

Hi,


the setup as following, I have 3 FWSM installed on 3 different 6513 switches, two of them are on active/standby failover mode and the last one installed on disaster recovery area as a backup stand alone FW.

My concern is to have the 3 FWSMs in failover which not supported till now as per Cisco release notes so I'm thinking whether the changes modified on the active/standby FWSMs could be replicated to the third FW via the CSM either manually or automatically (script or whatever) to keep it synchronized with the failover pair?s configuration.


Briefly speaking, I need the third FWSM to be on standby in case if any failure occurred on the head office zone.


Appreciate any helpful comments..


Regards,

Belal





  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion