Binding E1

Unanswered Question
Apr 7th, 2007
User Badges:

HI,


I want 8 mbps link. In this situation I want purchse one 2821 router and 4 VWIC-2MFT-E1 cards. How can I bind them so that It will work like one. Second,How can I load balance it.


Third, I have MWR 1941 router. How can I perform the above in this router . PLS Help ASAP.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Loading.
minumathur Sat, 04/07/2007 - 23:54
User Badges:
  • Bronze, 100 points or more

Hi


You need to configure multilink in router, give single ip address in multilink IP address with mask /30 & configure routing.


let me know anything more you required, please rate this post.


this link also help you, you need consider serail interface instead of dialer interface.


http://cisco.com/en/US/tech/tk713/tk507/technologies_configuration_example09186a0080093c1d.shtml


-minu

balajitvk Sun, 04/08/2007 - 03:31
User Badges:
  • Silver, 250 points or more

Hi,


You can use multilink concept to bind all these E1 to work like one.....


There is a documentation for you to tell how to bind them,


http://www.cisco.com/en/US/tech/tk713/tk628/technologies_configuration_example09186a00800a5efa.shtml


Itself enables the load-balancing of traffic from different links and allows some level of redundancy in case of a line failure on a single link.


Support of VWIC-2MFT-E1 on the platforms can be refered in the below document,


http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080091b9c.html


Cisco MWR 1941-DC router will support VWIC-2MFT-T1-DIR and multilink operation will be the same as other platforms


http://www.cisco.com/en/US/products/hw/routers/ps4062/prod_installation_guide09186a00801c9330.html


Rate if does,

Rgs.

Actions

This Discussion