04-09-2007 06:30 AM - edited 03-11-2019 02:57 AM
I'm preparing to implement a double firewall dmz with a couple of ASAs and while drawing it am getting a little confused on how to allow remote access and tunnels to work using the same ASAs that are being used for the double firewall DMZ configuration. Anyone have any advice or maybe a note outlining the config?
thank you,
Bill
Solved! Go to Solution.
04-13-2007 06:01 AM
Instead of multiple Firewall, you can use ASA with multi-context
You can partition a single security appliance into multiple virtual devices, known as security contexts. Each context is an independent device, with its own security policy, interfaces, and administrators. Multiple contexts are similar to having multiple standalone devices. Many features are supported in multiple context mode, including routing tables, firewall features, IPS, and management.
Refer this doc:
04-13-2007 06:01 AM
Instead of multiple Firewall, you can use ASA with multi-context
You can partition a single security appliance into multiple virtual devices, known as security contexts. Each context is an independent device, with its own security policy, interfaces, and administrators. Multiple contexts are similar to having multiple standalone devices. Many features are supported in multiple context mode, including routing tables, firewall features, IPS, and management.
Refer this doc:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: