Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
367
Views
0
Helpful
3
Replies

CE500 disabling trunk ports due to one-way traffic

jburk
Level 1
Level 1

‎04-09-2007 11:13 AM - edited ‎03-05-2019 03:22 PM

Hi all, I have two CE500 switches connected through 100mb ethernet PoE (smartport role set to switch) to 350 series bridges on both sides. Twice this week the remote side bridge has lost power and both sides disabled the trunk ports "due to one-way traffic only" - Does anybody know how to keep it from doing this?

Labels:
0 Helpful
3 Replies 3

jburk
Level 1
Level 1

‎04-11-2007 06:02 AM

has nobody seen this error?

0 Helpful

davidfloria
Level 1
Level 1
In response to jburk

‎05-14-2007 08:44 AM

Hello,

I have the same problem with two switches CE500 connected trough a fiber backbone with a transceptor on each side. It happens only on one of them. What thing can cause the message "one-way traffic" that disables the port?

Is there any procedure to disble the behavior of disabling the port?

Regards.

0 Helpful

jburk
Level 1
Level 1
In response to davidfloria

‎04-04-2008 07:31 AM

The problem seemed to go away after an upgrade to 12.2.25 SEG4

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card