CallManager 5 SIP URI call

Unanswered Question

Is it possible to place a SIP call to a SIP/SCCP endpoint that is registered with CCM from a SIP softphone (that is not registered with CCM). Basically, I am just trying to dial a SIP URI to call a phone that is registered with CallManager.

For example, I am trying to use a Linux-based softphone - Ekiga - to dial sip:[email protected] 50956 is an extension assigned to a Linksys SIP phone that is registered to CCM 10.244.2.10. Ekiga is not registered with CCM.

Whenver I try do dial this URI, Ekiga sends a SIP INVITE to CCM UDP port 5060, which then responds with:

SIP/2.0 503 Service Unavailable

I have also had the same result with the SIP cli-based testing tool sipsakk.

Does anyone know how to make this work?

If so, can I also dial SCCP endpoints via a SIP URI (and the B2BUA functionality in CCM will handle the SIP/SCCP signaling)?

I have been playing around with CCM 5.1 for a few weeks but have been unable to find any documentation about this.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gogasca Tue, 04/10/2007 - 10:14

You need to create a SIP trunk so CCM doesnt reject the call.

Can this be done without a SIP trunk?

I would like to be able to receive SIP calls from anyone on the Internet (like the Cisco SIP Proxy Server permitted before it went EOS).

I know that a second part of this is to setup a SIP SRV record for my domain so that sip:[email protected] works. Right now I am just trying to see if I can get CCM 5 to redirect a SIP INVITE from a softphone to a phone that is registered with callmanager.

Does CCM 5 even support URI-based dialing (sip:[email protected]), or just ENUM dialing (where DNS would need to be configured to support ENUM with a NAPTR record like 4.3.2.1.5.5.5.9.9.9.1.e164.arpa to dial 19995551234)?

Actions

This Discussion