Unanswered Question
Apr 10th, 2007

Hi guys i have a cisco 2811....if i want to check which dsp is installed or wherether dsp is instaled (PVDM) which command shd i use to check it.....regards

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Steven Griffin Tue, 04/10/2007 - 16:49

A 'Show Diag 0' will give you information about the motherboard and which kind and quantity of PVDM(s) are installed in it.

A 'Show Voice DSP Detailed' will give you information about which DSPWare your IOS load is using.

thisisshanky Tue, 04/10/2007 - 17:01

If you want to know the actual serial number and the part number of the DSP (like PVDM2-16 etc), you should use the command "Sh inventory".




This Discussion