04-11-2007 03:17 AM - edited 03-05-2019 03:24 PM
Hi all, I have recieved the setup config from my isp about my internet routers, they say they are load balanced, the config shows that on the fastethernet port that has the public ip on is in 2 groups, its standby for group 1 and active for group 2 on one router, and active for group 1 and standby for group 2 on the other, How is this working, I didnt realise you could have multiple groups on the same interface ?
04-11-2007 06:26 AM
Yes, you can do it, it's one of the features of HSRP:
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094a91.shtml#multihsrp
And an example:
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_configuration_example09186a0080094e90.shtml
Regards
Hope this helps, if so pls rate post
04-11-2007 11:47 AM
why would we have 2 groups assigned to the same interface, the interface only had one ip address too ?
04-11-2007 12:07 PM
why would we have 2 groups assigned to the same interface, the interface only had one ip address too ?
04-11-2007 03:34 PM
hi friend,
by configring 2 HSRP grps. do u wanna achieve load balancing on both the link to ISP ??
if this is the case i would suggest GLBP is right choice.
amit
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: