04-11-2007 09:50 AM
Hi,
I have configured bridge-group for dlsw on a Fastethernet dot1q encapsulated subinterface.
on the switch I have seen the remote mac-address learned in vlan 1 (untagged vlan of the trunk) and I have not seen that mac-address on vlan 3 as it was aspected.
here is the configuration:
!
interface FastEthernet0/0
no ip address
duplex auto
speed auto
!
interface FastEthernet0/0.2
description lan SERVIZIO
encapsulation dot1Q 2
ip address 10.245.21.90 255.255.255.248
!
interface FastEthernet0/0.3
description lan UFFICIO
encapsulation dot1Q 3
ip address 10.54.244.9 255.255.254.0
ip helper-address 10.199.31.66
bridge-group 1
!
dlsw local-peer peer-id 10.54.244.9
dlsw remote-peer 0 tcp 10.190.101.81
dlsw icannotreach sap F0
dlsw bridge-group 1
!
bridge 1 protocol ieee
04-13-2007 02:11 PM
Hi Massimiliano,
Are you possibly using an older version of IOS? This was not supported until later versions (~13) of 12.2. Otherwise what you have looks OK.
Rgds, Dan
04-16-2007 01:11 AM
Hi Dan,
thank you for your answer.
The problem was no longer seen changing the switch (a non-cisco switch was installed).
the ios is a 12.2-17a and it supports dlsw bridging on dot1q trunk.
thank you
Massimiliano
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: