04-12-2007 02:15 AM - edited 07-03-2021 01:54 PM
I am configuring point-to-multipoint outdorr W'less mesh network using 1500.
Since 1550 requires WLC ( Wireless LAn Controller ) I have configured one at central site.
Q1. Does each remote site also requires WLC at respective locations ?
Q2. Can the bridge functionality in 1500 support extending multi[pla VLAN traffic to the remote 1500 ?
04-17-2007 12:09 AM
hai sam
Iam also in the same boat.i want to configure point to multipoint outdoor using 1300....
if u hav any idea about this can share with me ,so that it wud b helpful in configuring it.
can u just tell me wat is a subscriber unit?
awaiting for ur reply...
04-17-2007 04:35 AM
If you converted your 1300 to lwapp you lose the bridging. If your ios based try this document
http://www.cisco.com/en/US/products/ps5861/products_configuration_guide_chapter09186a008021e5de.html
04-17-2007 04:27 AM
a Mesh Access Point (MAP) can have an ethernet connection. so you don't have to have a wlc on each site.
try these documents http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo1500/ap1500qs.pdf
http://www.cisco.com/application/pdf/en/us/guest/netsol/ns171/c649/ccmigration_09186a008077c05d.pdf
04-23-2007 01:30 AM
My local MAP ( mesh Access Point ) can have WLC attached to its Ethernet port. But, how about the remote MAP ? Does it also requires another WLC connected to its Ethernet Port for the propoer operation?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: