Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
940
Views
0
Helpful
2
Replies

AP 1242 AG et IPv6

tsalon
Level 1
Level 1

‎04-12-2007 04:11 AM - edited ‎07-03-2021 01:55 PM

I would implement IPv6 in my network equipement(3560, 2811 ,etc.)but i don't find the good IOS for an Aeronet 1242AG

For further details, it seems there is no "Advenced ip services" IOS for Wirless equipement.

Also i have try to activate IPv6 in my classical IOS (Sdm prefer dual...)without result.

If somebody know a solution for my problem !!!

Labels:
0 Helpful
2 Replies 2

fmeetz
Level 4
Level 4

‎04-18-2007 12:21 PM

IPv6 traffic is transparently forwarded by Cisco Wireless Access Point. No specific configuration is required on Cisco IOS based Access Point. On Centralized Architecture (Cisco WLC 4400, LWAPP'd AP's) IPv6 pass through must be validated through the GUI.

0 Helpful

Matt Wilson
Level 1
Level 1
In response to fmeetz

‎12-15-2017 04:39 AM

How does one relate IPv6 VLANs to IPv4 VLANS on an IPv4 only IOS?

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card