MGCP & Fractional E1

Unanswered Question
Apr 12th, 2007
User Badges:

Hi,


Can anybody confirm whether it is possible to configure a single 2851 Router to support both MGCP and H323.


I have a 2 Port E1 card installed in the Router. The first Port is in use and configured for MGCP with a Call Manager 5.1 installation.


However another Pri E1 circuit has been provisoned with 10 Channels on the 2nd E1 interface. As MGCP does not support fractional E1 I would like to config this circuit as H323 while still maintaining my existing MGCP config on the 1st E1 interface.


Any advice would be appreciated.


Regards


Ian.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Brandon Buffin Thu, 04/12/2007 - 09:31
User Badges:
  • Purple, 4500 points or more

Ian,

Yes, you can use both MGCP and H.323 on the same router. Simply leave off the "service mgcp" portion of the pri-group command under the configuration for the new controller. So you would configure something similar to:


controller e1 1/0/1

pri-group timeslots 1-10


You can then create dial peers in IOS and a new gateway in CCM admin.


Hope this helps.


Brandon

Actions

This Discussion