cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
371
Views
0
Helpful
2
Replies

communication between vlans

erodrig
Level 1
Level 1

Hi

how can i do to communicate vlans only in one way? i mean i have vlan 2 and vlan 3, and i want that traffic from vlan 2 can see hosts of vlan 3, but traffic from vlan 3 can not see hosts in vlan 2, is this posible?

thanks

2 Replies 2

spremkumar
Level 9
Level 9

hi

you can configure VACL's to achieve your requirement.. But you should make sure that your platform and the ios version/feature set installed in that supports the same..

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080160a7e.html

regds

avillalva
Level 1
Level 1

Look into reflexive access lists.

In summary, they are similar to using the established key word but also apply to icmp and udp. That way, you can have one side with full access to the other, but not vice versa.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a00800d9817.html

HTH,

Andres

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: