04-12-2007 11:06 AM - edited 03-03-2019 04:31 PM
Hi there,
I have two Cisco 2851 routers each with a VWIC-2MFT-E1 module. What kind of cable should I use to connect them point-to-point in a close distance and if possible any working configuration.
Thanks,
Klean...
04-12-2007 11:34 PM
Hi
You need to reverse the pin outs on the other end connecting to the router.
Normally the signal comes on 1,2 & 4,5 pairs ,one side you keep this and on the other side you just reverse the same which i feel should work..
http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b6e0f.shtml
regds
04-12-2007 11:37 PM
Yes a back to back T1/E1 cable works
1--4
2--5
HTH, rate if it does
Narayan
04-12-2007 11:46 PM
Hi
You need to use cross cable , with pin detail are below
1--4
2--5
4--1
5--2
if i am recall correctly , 1&2 are RX and 4&5 are TX.
-Minu
please rate this post.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide