I am evaluating CSM as a replacement for VMS, but I can't seem to add my IDSM2 and FWSM modules.
I tried adding the modules directly, but then I read something that said I needed to add them through my SUP. Is this correct?
When I try to add the IDSM2 (5.1 )directly, the error log indicates that CSM issues the "show run" command while collecting inventory. Shouldn't it be using "show config"?
When I try to add it thorough the SUP, I can see CSM log in, but it never issues the enable password even though one is specified.
I've tried ssh v1 and 2. Key modulus is 1024. I've tried adding it from DCR and directly over the network.
Any ideas at this point would be greatly appreciated!